Out of the Box Diamond Multimedia put together an interesting piece of hardware here. It’s a very compact wireless repeater device that is compatible with the N standard.

Inside the box, you’ll find the device, an Ethernet cable, an Easy Start Guide and some documentation and software on CD to set things up. Physically, the repeater unit is pretty small. It’s the size of a mid-sized AC adapter, so It may take up some space on a surge-protector strip.

It’s really plastic-y, and is adorned with an Ethernet port, a small WPS switch – a welcome convenience if you use that on your network – and a few status LEDS. All in all, it doesn’t look too fancy, but it’s definitely smaller than a full-sized repeater.

View and Download Diamond Multimedia WR300N quick start manual online. Diamond Multimedia Portable Wireless-N Repeater. WR300N Repeater pdf manual download. 1 Wireless-N Wi-Fi Repeater/ Extender Quick Installation Guide 04-0867A Introduction The Wireless-N Wi-Fi Repeater/Extender can extend and increase signal strength.

You’ll also find a small recessed “reset” button next to the Ethernet port on the bottom of the unit. Configuration To get things started, you plug the repeater into the wall or a surge protector, hook it up to your computer via Ethernet, and then point your browser to 10.0.10.254. To be certain you don’t have any problems, it’s a good idea to disconnect your computer from any other networks and restart your computer so that no other settings interfere with what you’re doing here. Not doing this has given me problems before, and it’s a small price to pay to make sure things move along as smoothly as silk. The default username and password are both “admin”.

The main page should look like below (click on image to see it full-size): There’s an “Automatic Setup” mode in the web interface, so I really didn’t bother with using the CD setup. Clicking on Auto Setup just takes you to a Site Survey page where you choose which network you’d like to repeat, and that’s pretty much it (click on image below to see it full-size). You just click Refresh until your network appears in the list, then click connect. That’s really it.

In addition to this quick setup, the WR300N offers an Access Point mode, a Wireless Bridge mode, and a manual configuration for Repeater mode, but first, I made a few necessary changes to the device’s settings. Preliminary Changes The first thing I did was change the default password. You can do this by clicking on the System button then clicking Password. The second thing I decided to do was change the IP Address of the unit to fit my network’s scheme. You’ll find this setting under System >Local. Access Point Mode If you click on the Manual Setup button and then choose “Access Point” from the Operation Mode menu, you’ll see the following options: Using the WR300N as an Access Point will allow you to add wireless functionality from a wired networking device.

You can specify an SSID and encryption and it’ll do its thing. Ricardo Villalobos Alcachofa Rarity. In my testing, I found that the wireless range was very nice, probably due to the fact that this is an N-standard capable device. Using this as an access point, however, did cause some bottlenecking to occur in comparison to using the wireless on my old WRT54G v1 router running DD-WRT. It was close to comparable for the most part, and the inclusion of this mode is nice, though. Cash Textbook Of Neurology For Physiotherapists Pdf Writer there. Wireless Bridge Mode Choosing “Wireless Bridge” from the Operation Mode menu will give you pretty much the same set of options: Wireless Bridge mode lets you do the opposite of Access Point mode: catch a wireless signal and use the Ethernet port to connect to a wired-only device. I tested this with both an Xbox 360 and a desktop computer, both without any problems. It was a pretty simple and straightforward endeavor, and for a change, I was using it on a G-only network.